ECD SYSTEM (for DPF) > PRECAUTION |
| 1.IGNITION SWITCH EXPRESSION |
| Expression | Ignition Switch (position) | Engine Switch (condition) |
| Ignition Switch off | Off | Off |
| Ignition Switch ON | ON | On (IG) |
| Ignition Switch ACC | ACC | On (ACC) |
| Engine Start | START | Start |
| 2.INITIALIZATION AND REGISTRATION |
| Replacement Part | Utility Item |
| ECM |
|
| Engine assembly |
|
| Crankshaft position sensor plate | Clear Crank Time Compensation Data (Click here) |
| A/F sensor | Clear A/F Sensor Compensation data (Click here) |
| Supply pump | Supply Pump Initialization (Click here) |
| DPF catalyst | Clear DPF Thermal Deterioration Data (Click here) |
| Injector |
|
| 3.CATALYST RECORD OF DPF THERMAL DETERIORATION |
When only the DPF catalyst is replaced.
After replacing the DPF catalyst, clear the thermal deterioration data stored in the ECM (Click here).
When only the ECM is replaced.
After replacing the ECM, input the original thermal deterioration data stored before replacement .
After replacing both the DPF catalyst and the ECM, clear the thermal deterioration data stored in the new ECM (Click here).
| 4.INJECTOR COMPENSATION CODE |
![]() |
When an injector is replaced, the injector compensation code must be input into the ECM .
When the ECM is replaced, all of the existing injector compensation codes must be input into the new ECM .
| 5.PILOT QUANTITY LEARNING |
When an injector is replaced, the injector compensation code must to be input to the ECM and then perform the pilot quantity learning .
When the ECM is replaced, all of the existing injector pilot quantity learning values must be input into the new ECM .
| 6.DIFFICULT TO START ENGINE, ENGINE STALLING, BLACK SMOKE EMITTED ROUGH IDLING, EXCESSIVE ENGINE VIBRATION, ENGINE KNOCKING, LACK OF POWER OR HESITATION |
Check if the customer problem is described below. If so, refer to the appropriate troubleshooting section.
Engine is difficult to start or stalls.
Black smoke is emitted.
Rough Idling or Excessive Engine Vibrations.
Engine Knocking or Rattling.
Lack of Power or Hesitation.
| 7.WHEN USING INTELLIGENT TESTER |