STEERING COLUMN ASSEMBLY (for RHD) > DISASSEMBLY |
| 1. REMOVE TRANSPONDER KEY AMPLIFIER (w/o Smart Entry and Start System) |
![]() |
Detach the 2 claws and slide the transponder key amplifier in the direction shown in the illustration, to remove it from the steering column upper with switch bracket.
| 2. REMOVE STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY (w/o Smart Entry and Start System) |
Fix the steering column in a vise between aluminum plates.
Using a drill, drill a hole in the steering lock set bolt to insert a screw extractor.
![]() |
Using the screw extractor, remove the steering lock set bolt then and remove the steering column upper with switch bracket.
| 3. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Smart Entry and Start System) |
Insert the key and turn it to the ACC position.
![]() |
Insert the tip of a screwdriver into the hole in the steering column upper with switch bracket, as shown in the illustration, and pull the ignition switch lock cylinder out until its claw comes into contact with the stopper of the steering column bracket upper.
![]() |
Insert the tip of a screwdriver into the hole in the steering column bracket and tilt it downward, as shown in the illustration, to disengage the claw of the ignition switch lock cylinder. Then pull out the ignition switch lock cylinder.
| 4. REMOVE UNLOCK WARNING SWITCH ASSEMBLY (w/o Smart Entry and Start System) |
![]() |
Push up the center portion of the unlock warning switch center portion to detach the 2 claws.
| 5. REMOVE KEY INTERLOCK SOLENOID (w/o Smart Entry and Start System) |
![]() |
for Automatic Transaxle:
Remove the 2 screws and key interlock solenoid from the steering column upper with switch bracket.
| 6. REMOVE IGNITION SWITCH ASSEMBLY (w/o Smart Entry and Start System) |
![]() |
Remove the 2 screws and ignition switch from the steering column upper with switch bracket.
| 7. REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/ Smart Entry and Start System) |
Fix the steering column in a vise between aluminum plates.
Using a drill, drill a hole in the steering lock set bolt to insert a screw extractor.
![]() |
Using the screw extractor, remove the steering lock set bolt and remove the steering lock actuator.