Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals 13 (TC) and 4 (CG) of the DLC3 enables DTCs to be read through blinking patterns of the combination meter's CRUISE main indicator light.

HINT:
When a warning light of the combination meter blinks continuously, terminal 13 (TC) of the DLC3 or the ECM may have a ground short.


WIRING DIAGRAM


E110507E03


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (DLC3 - ECM AND BODY GROUND)
E125994E06
  1. Disconnect the E16 DLC3 connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E16-13 (TC) - A12-26 (TC)
    Below 1 Ω
    E16-4 (CG) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM