AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION |
| 1. CHECK PRESSURE SENSOR |
![]() |
Check the wire harness.
Disconnect the connector of the pressure sensor.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| 1 - Body ground | Below 1 Ω |
Turn the ignition switch on (IG).
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| 1 - 3 | 4.7 to 5.3 V |
![]() |
Check the pressure sensor.
Set the manifold gauge.
Connect the connector to the pressure sensor.
Warm up the engine.
Switch the A/C ON.
Measure the voltage.
| Tester Connection | Refrigerant Pressure | Specified Condition |
| for Automatic Air Conditioner: E41-9 (PRE) - E41-13 (SG-2) | 0.176 to 3.025 MPa (1.8 to 30.9 kgf/cm2) | 0.76 to 4.74 V |
| for Manual Air Conditioner: E42-12 (PRE) - E42-10 (SG-2) | 0.176 to 3.025 MPa (1.8 to 30.9 kgf/cm2) | 0.76 to 4.74 V |