AUTOMATIC TRANSAXLE SYSTEM > INITIALIZATION |
| RESET TRANSAXLE COMPENSATION CODE |
Move the shift lever to N or P.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Utility / A/T Code Reset.
Press "Next" to proceed.
Press "Exit".
| RESET MEMORY |
The reset procedure is as follows.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: "Powertrain / ECT / Utility / Reset Memory". Then press "Next".
| PERFORM ROAD TEST TO ALLOW TCM TO LEARN |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List / Accel Position from EFI.
From a standstill, achieve the highest possible speed with the accelerator pedal depressed 15% or less. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.
From a standstill, achieve the highest possible speed with the accelerator pedal depressed 25% to 35%. Keep the accelerator pedal angle steady while driving the vehicle.
Repeat the previous step until shift shock no longer occurs.