STARTER RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT STARTER RELAY (ST) |
![]() |
for LHD:
Remove the starter relay from the No. 7 relay block.
for RHD:
Remove the starter relay from the No. 8 relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
for LHD:
Install the starter relay to the No. 7 relay block.
for RHD:
Install the starter relay to the No. 8 relay block.