STARTER CUT RELAY (w/ Entry and Start System) > ON-VEHICLE INSPECTION |
| 1. INSPECT STARTER CUT RELAY (ST CUT) |
![]() |
Remove the starter cut relay from the No. 7 relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
Install the starter cut relay to the No. 7 relay block.