Home › ENGINE · 2AD-FTV › STARTING › STARTER RELAY

STARTER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STARTER RELAY (ST)


B060778E26
  1. for LHD:
    Remove the starter relay from the No. 7 relay block.

  1. for RHD:
    Remove the starter relay from the No. 8 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the starter relay.

  1. for LHD:
    Install the starter relay to the No. 7 relay block.

  1. for RHD:
    Install the starter relay to the No. 8 relay block.