ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION |
| 1. CHECK ACCELERATOR PEDAL ROD |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.
Operate the accelerator pedal rod, and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.
| Accelerator Pedal Condition | Specified Condition |
| Released | 8 to 28% |
| Depressed | 30 to 55% |
| Accelerator Pedal Condition | Specified Condition |
| Released | 51 to 86% |
| Depressed | 73 to 98% |