FRONT POWER SEAT CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK POWER SEAT FUNCTION |
![]() |
Check the basic functions.
Operate the power seat switches and check to make sure each seat function works:
| 2. CHECK FRONT SEAT FRAME WITH ADJUSTER (SLIDING, FRONT VERTICAL, LIFTER AND RECLINING FUNCTIONS) |
Check the PTC operation inside the power seat motor.
Choose a power seat function. Operate the power seat switch and move the seat as much as possible in one direction. Keep the seat in that position for approximately 60 seconds.
Operate the power seat switch again and continue to try to move the seat in the same direction as in the previous step. Measure the amount of time elapsed before current is automatically cut (the sound of the motor has stopped).
After current has been cut, release the power seat switch and wait for approximately 60 seconds.
Operate the same power seat switch and move the seat in the opposite direction. Check that the motor operates.
| 3. CHECK LUMBAR SUPPORT ADJUSTER ASSEMBLY |
Check the PTC operation inside the power seat motor.
Operate the lumbar support switch and move the lumbar support to either the foremost or rearmost position. Keep the seat in that position for approximately 60 seconds.
Operate the lumbar support switch again and continue to try to move the lumbar support in the same direction as in the previous step. Measure the amount of time elapsed before current is automatically cut (the sound of the motor has stopped).
After current has been cut, release the lumbar support switch and wait for approximately 60 seconds.
Operate the lumbar support switch and move the seat in the opposite direction. Check that the motor operates.