Home › ENGINE · 2AD-FTV › STARTING › ENTRY AND START SYSTEM

DTC    B2271    Ignition Hold Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when the IG output circuits inside the main body ECU are open or shorted.

DTC Code
DTC Detection Condition
Trouble Area
B2271
IG1 relay actuation circuit or IG2 relay actuation circuit inside the main body ECU is abnormal.
  1. Main body ECU
  2. AM2-2 fuse
  3. Harness or connector

WIRING DIAGRAM


C164714E04


INSPECTION PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the intelligent tester on.

  1. Clear the DTCs.

  1. Start the engine.

  1. Allow the engine to idle for 1 minute or more.

  1. Enter the following menus: Body / Main Body / DTC.

  1. Read the DTCs.
    Result 
    Result
    Proceed to
    B2271
    A
    No DTC output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2.INSPECT FUSE (AM2-2)
  1. Remove the AM2-2 fuse from the engine room No. 1 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    AM2-2 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND)


    B127996E07
  1. Disconnect the E18 and E19 main body ECU connectors.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E19-1 (AM1) - Body ground
    Always
    11 to 14 V
    E18-6 (AM2) - Body ground
    Always
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E19-4 (GND2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)