DTC B2275 STSW Monitor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2275 | Engine start request signal circuit inside the main body ECU or other related circuit is malfunctioning. |
|

| 1.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Enter the following menus: Body / Main Body / DTC.
Clear the DTCs.
Depress the brake pedal (except M/T) or clutch pedal (for M/T) with the engine switch on (IG), wait at least 15 seconds, and check whether DTC B2275 recurs.
| Result | Proceed to |
| B2275 | A |
| No DTC output | B |
|
| ||||
| A | |
| 2.CHECK MAIN BODY ECU (STSW VOLTAGE) |
![]() |
Disconnect the E20 main body ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E20-4 (STSW) - Body ground | Brake pedal (except M/ T) or clutch pedal (for M/T) depressed with shift lever in P or N (except M/T) and engine switch pushed once | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
![]() |
Disconnect the E20 main body ECU connector.
Disconnect the A12 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E20-4 (STSW) - A12-19 (STSW) | Always | Below 1 Ω |
| E20-4 (STSW) or A12-19 (STSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK WHETHER ENGINE STARTS |
Temporarily replace the main body ECU (instrument panel junction block) with a new or normally functioning one.
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||