Home › ENGINE · 2AD-FTV › STARTING › ENTRY AND START SYSTEM

DTC    B2275    STSW Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when the engine start request signal circuit inside the main body ECU is open or shorted.

DTC Code
DTC Detection Condition
Trouble Area
B2275
Engine start request signal circuit inside the main body ECU or other related circuit is malfunctioning.
  1. Main body ECU
  2. ECD system
  3. Harness or connector

WIRING DIAGRAM


A122229E43


INSPECTION PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / DTC.

  1. Clear the DTCs.

  1. Depress the clutch pedal with the engine switch on (IG), wait at least 15 seconds, and check whether DTC B2275 recurs.
    Result 
    Result
    Proceed to
    B2275
    A
    No DTC output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2.CHECK MAIN BODY ECU (STSW VOLTAGE)


    A122230E11
  1. Disconnect the E20 main body ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    HINT:
    The voltage is generated at terminal STSW for 0.3 seconds when the engine cranks.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E20-4 (STSW) - Body ground
    Clutch pedal depressed and engine switch pushed once
    11 to 14 V



NG
Go to step 4
OK


3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)


    A126728E18
  1. Disconnect the E20 main body ECU connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E20-4 (STSW) - A12-19 (STSW)
    Always
    Below 1 Ω
    E20-4 (STSW) or A12-19 (STSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK WHETHER ENGINE STARTS
  1. Temporarily replace the main body ECU (instrument panel junction block) with a new or normally functioning one.

  1. Check that the engine starts normally.

    OK:
    Engine starts normally.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for DPF)
    B
    NG (for CCo)
    C



B
GO TO ECD SYSTEM (Click here)

C
GO TO ECD SYSTEM (Click here)
A

END (MAIN BODY ECU IS DEFECTIVE)