Home › ENGINE · 2AD-FHV › STARTING › ENTRY AND START SYSTEM

DTC    B2287    LIN Communication Master Malfunction

DTC    B2289    Key Collation Waiting Time Over

for Preparation Click here


DESCRIPTION

DTC B2287 is stored when the LIN communication circuit between the main body ECU and certification ECU is abnormal. DTC B2289 is stored when there is a malfunction in the immobiliser system.

DTC Code
DTC Detection Condition
Trouble Area
B2287
Communication or the communication line between the main body ECU and certification ECU is abnormal.
  1. Main body ECU
  2. ECU aggregation box (Certification ECU)
  3. Harness or connector
B2289
Either condition is met:
  1. Communication or the communication line among the main body ECU, certification ECU, steering lock ECU and ID code box is abnormal.
  2. Immobiliser system malfunctions.
  1. Main body ECU
  2. Engine immobiliser system (w/ Entry and Start System)
  3. Harness or connector
  4. Engine switch
  5. Entry function
  6. Electrical key

A209867E01


WIRING DIAGRAM


A165875E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CERTIFICATION ECU)


    A122425E09
  1. Disconnect the ID instrument panel junction block connector.

  1. Disconnect the E63 certification ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ID-9 (LIN1) - E63-10 (LIN)
    Always
    Below 1 Ω
    ID-9 (LIN1) or E63-10 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK CERTIFICATION ECU
  1. Temporarily replace the ECU aggregation box (certification ECU) with a new one.

    NOTICE:
    When replacing the certification ECU, registration procedures must be performed. Refer to Service Bulletin.

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
OK

END (CERTIFICATION ECU IS DEFECTIVE)