AIRBAG SYSTEM > TC and CG Terminal Circuit |

| 1.CHECK WIRE HARNESS (DLC3 - ECM) |
![]() |
Turn the ignition switch off.
Disconnect the A12 connector from the center airbag sensor.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E16-13 (TC) - A12-26 (TC) | Below 1 Ω |
| Tester Connection | Specified Condition |
| E16-13 (TC) - A12-27 (TC) | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND) |
![]() |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E16-4 (CG) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (TC OF DLC3) |
![]() |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E16-13 (TC) - Body ground | 1 MΩ or higher |
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM.
Check the DTC of the ECM.
| Result | Proceed to |
| DTC output mode is set (except center airbag sensor). | A |
| Normal system code is output. | B |
| DTC is output. | C |
|
| ||||
|
| ||||
| A | ||
| ||