VEHICLE STABILITY CONTROL SYSTEM > CHECK FOR INTERMITTENT PROBLEMS |
| CHECK FOR INTERMITTENT PROBLEMS |
Turn the ignition switch off and connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
![]() |
Follow the prompts on the intelligent tester to display the Data List and select areas where a momentary interruption should be monitored.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Speed Open | FR speed sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption NORMAL: Normal | - |
| FL Speed Open | FL speed sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption NORMAL: Normal | - |
| RR Speed Open | RR speed sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption NORMAL: Normal | - |
| RL Speed Open | RL speed sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption NORMAL: Normal | - |
| EFI Communication Open | EFI communication open detection / ERROR or NORMAL | ERROR: Momentary interruption NORMAL: Normal | - |
| Yaw Rate Open | Yaw rate sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption NORMAL: Normal | - |
| Deceleration Open | Deceleration sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption NORMAL: Normal | - |
| Steering Open | Steering angle sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption NORMAL: Normal | - |
| Master Cylinder Open | Master cylinder pressure sensor open detection / ERROR or NORMAL | ERROR: Momentary interruption NORMAL: Normal | - |
![]() |
While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs. If the display changes, the connector and/or wire harness is in momentary interruption (open circuit). Repair or replace the connector and/or wire harness, as one of them is faulty.