Home › TRANSMISSION · U660F AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > Pattern Select Switch Sport Mode Circuit

for Preparation Click here


DESCRIPTION

The TCM memory contains the programs for the normal and sport shift patterns.
By following the programs corresponding to the signals from the No. 1 pattern select switch assembly, park/neutral position switch and other various sensors, the TCM switches the shift solenoid valves on and off, and controls the transaxle gear ratio.

WIRING DIAGRAM


C206830E03


INSPECTION PROCEDURE

1.INSPECT NO. 1 PATTERN SELECT SWITCH ASSEMBLY


    C202152E01
  1. Remove the No. 1 pattern select switch assembly .

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (MSW1) - 3 (MSW2)
    Pattern select switch on
    Below 1 Ω
    6 (MSW1) - 3 (MSW2)
    Pattern select switch off
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (No. 1 Pattern Select Switch Assembly)



NG
REPLACE NO. 1 PATTERN SELECT SWITCH ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (NO. 1 PATTERN SELECT SWITCH ASSEMBLY - BODY GROUND)


    C203350E01
  1. Disconnect the No. 1 pattern select switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E101-3 (MSW2) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to No. 1 Pattern Select Switch Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (NO. 1 PATTERN SELECT SWITCH ASSEMBLY - ECM)


    C197708E12
  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A12-36 (PWMS) - Body ground
    Pattern select switch on
    Below 1 Ω
    A12-36 (PWMS) - Body ground
    Pattern select switch off
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)