DTC B2276 ACCR Signal Circuit Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2276 | ACCR output circuit inside the main body ECU or other related circuit is malfunctioning. |
|

| 1.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Enter the following menus: Body / Main Body / DTC.
Clear the DTCs.
Check whether DTC B2276 recurs 50 seconds or more after the engine switch is turned on (IG).
| Result | Proceed to |
| B2276 | A |
| No DTC output | B |
|
| ||||
| A | |
| 2.CHECK MAIN BODY ECU (ACCR VOLTAGE) |
![]() |
Disconnect the E20 main body ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E20-11 (ACCR) - Body ground | When all condition are met:
| 0.1 to 0.8 V* → ((Voltage at terminal AM21 or AM22) minus 2.0 V) or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the E20 main body ECU connector.

Disconnect the A12 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E20-11 (ACCR) - A12-51 (ACCR) | Always | Below 1 Ω |
| E20-11 (ACCR) or A12-51 (ACCR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK MAIN BODY ECU |
Temporarily replace the main body ECU (instrument panel junction block) with a new or normally functioning one.
Check whether DTC B2276 recurs by repeating the "CHECK WHETHER DTC OUTPUT RECURS" procedures above.
|
| ||||
| OK | ||
| ||