ENTRY AND START SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Using the intelligent tester, check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs and note any stored DTCs (Click here ).
Delete the DTC.
Check whether the same DTC(s), relevant to the ECD or entry and start systems, recurs by reproducing the symptoms indicated by the noted DTC(s) in first step above.
| Result | Proceed to |
| DTC output does not reoccur | A |
| ECD system DTC output reoccurs | B |
| Entry and start system DTC output reoccurs | C |
|
| ||||
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here)
Data List / Active Test (Click here)
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|