Home › ENGINE ยท 2AD-FTV › STARTING › IGNITION SWITCH (w/o Entry and Start System)

IGNITION SWITCH (w/o Entry and Start System) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE LOWER STEERING COLUMN COVER


    A194728
  1. Detach the 4 claws, release the tilt lever and remove the lower steering column cover.



3. REMOVE IGNITION SWITCH ASSEMBLY


    A210298
  1. Disconnect the ignition switch connector.

  1. Detach the clamp and disconnect the wire harness.



    A210296
  1. Remove the 2 screws and ignition switch.