Home › ENGINE ยท 2AD-FHV › FUEL › FUEL TANK

FUEL TANK > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FUEL TANK CAP


3. REMOVE FRONT FLOOR COVER


    A126770
  1. Remove the nut, bolt, 3 clips and floor cover.



4. REMOVE NO. 1 FLOOR UNDER COVER


    A124659
  1. Remove the 2 nuts, clip and floor under cover.



5. DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY


    A131635
  1. Remove the 2 bolts and disconnect the parking brake cable.



6. REMOVE NO. 1 FUEL TANK PROTECTOR
  1. Remove the 3 clips, 2 bolts and fuel tank protector.



7. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    A209411E01
  1. Pinch and pull the main tube connector to disconnect the connector from the pipe.
    Text in Illustration 
    *1
    Pipe
    *2
    Fuel Tube Connector
    *3
    Retainer
    *4
    O-Ring
    *5
    Nylon Tube

    NOTICE:
    1. Check for foreign matter in the pipe and around the connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the pipe and connector.
    2. Do not use any tools to separate the pipe and connector.
    3. Do not forcefully bend or twist the nylon tube.
    4. Check for foreign matter on the sealing surface of the pipe. Clean if necessary.
    5. Put the pipe and connector ends in plastic bags to prevent damage and foreign matter contamination.
    6. If the pipe and connector are stuck together, pinch the connector between your fingers and turn it carefully to disconnect it.



8. DISCONNECT FUEL TANK RETURN TUBE


    A209412
  1. Disconnect the fuel tank return tube.



9. DISCONNECT FUEL TANK TO FILLER PIPE HOSE


    A124662
  1. Disconnect the filler pipe hose from the fuel tank.



10. DISCONNECT FUEL TANK BREATHER HOSE


    A131627
  1. Disconnect the breather hose from the fuel tank.



11. REMOVE FUEL TANK FILLER PIPE
  1. Remove the 3 bolts and filler pipe protector.

  1. Remove the 2 bolts and filler pipe.



12. REMOVE FUEL TANK ASSEMBLY
  1. Set a transmission jack underneath the fuel tank.



    A124665
  1. Remove the 6 bolts and 3 fuel tank bands.

  1. Slightly lower the transmission jack.

    NOTICE:
    Be careful not to cut the wiring.



    A125366E02
  1. Fold back approximately half of each cushion rubber so that the wire harness can be detached from the fuel tank in the step below.
    Text in Illustration 
    *1
    Fuel Tank Cushion
    *2
    Wire Harness

  1. Disconnect the sender gauge connector.

    NOTICE:
    1. Before this procedure, check the connector for dirt, mud or other contamination.
    2. Do not use any tools in this procedure.

  1. Detach the wire harness from the 2 clamps and remove the fuel tank.