Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › TRANSMISSION CONTROL CABLE ASSEMBLY

TRANSMISSION CONTROL CABLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A203808
  1. Detach the 4 clips and remove the engine cover.

    NOTICE:
    Attempting to detach both the front and rear clips at the same time may cause the cover to break.



2. REMOVE AIR CLEANER CAP AND HOSE


    A208830
  1. Detach the clamp and disconnect the mass air flow meter connector.

  1. Disconnect the PCV hose.

  1. Disconnect the air cleaner hose.

  1. Detach the 3 clips and remove the air cleaner cap.



3. REMOVE AIR CLEANER CASE


    A208831
  1. Detach the clamp.

  1. Remove the 3 bolts and air cleaner case.



4. DISCONNECT FUEL FILTER ASSEMBLY


C209708
  1. Disconnect the level warning switch connector and detach the connector clamp.

  1. Remove the bolt, and slide the fuel filter upward to disconnect it from the air cleaner bracket.



5. REMOVE AIR CLEANER BRACKET


A208834
  1. Remove the 2 nuts and air cleaner support.



    C209709
  1. Disconnect the glow relay.



    A208835
  1. Detach the 3 wire harness clamps.

  1. Detach the 2 fuel hoses from the bracket.

  1. Remove the 3 bolts and bracket.



6. REMOVE FRONT FLOOR COVER


    A130273
  1. Remove the nut, bolt and clip, and then detach the 2 clips and remove the floor cover.



7. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
  1. Remove the rear console box (Click here).



8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.



    C203403
  1. Disconnect the end of the transmission control cable assembly from the shift lever.



    C127813E02
  1. Pull out the stopper of the transmission control cable.
    Text in Illustration 
    *1
    Stopper
    *2
    Nut

    NOTICE:
    Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

  1. Rotate the nut of the transmission control cable counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

    NOTICE:
    Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.



    C207570
  1. Remove the nut and disconnect the control cable assembly from the control shaft lever.

  1. Remove the clip and disconnect the transmission control cable from the control cable bracket.



    C127837
  1. Remove the 2 bolts and disconnect the transmission control cable.

  1. Pull out the transmission control cable to remove it.