Home › TRANSMISSION ยท EA64F MANUAL TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > INSPECTION

for Preparation Click here



1. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH


    C117496
  1. Hold the front differential pinion to the front differential case side. Using a dial indicator, measure the backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.0020 to 0.0079 in.)

    If the backlash is out of the specification, install proper side gear thrust washers.



2. INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER


    C068517
  1. Using a micrometer, measure the thickness of the thrust washer.

    Minimum thickness:
    0.54 to 0.66 mm (0.0213 to 0.0260 in.)

    If the thickness is less than the minimum, replace the front differential pinion thrust washer.



3. INSPECT NO.1 FRONT DIFFERENTIAL PINION SHAFT


    C068518
  1. Using a micrometer, measure the diameter of the pinion shaft.

    Minimum diameter:
    20.499 to 20.520 mm (0.8070 to 0.8079 in.)

    If the diameter is less than the minimum, replace the No. 1 front differential pinion shaft.