Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK RADIO RECEIVER ASSEMBLY

E177199E02

  1. Disconnect the E90 radio receiver connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND (E90-7) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    ACC (E90-3) - Body ground
    GR - Body ground
    ACC power supply
    Ignition switch on (ACC)
    11 to 14 V
    B (E90-4) - Body ground
    L - Body ground
    Battery power supply
    Always
    11 to 14 V
    ILL+ (E90-10) - Body ground
    G - Body ground
    Illumination signal
    Light control switch TAIL
    11 to 14 V
    SNS2 (E102-1) - Body ground*
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the results are not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the E90 radio receiver connector.

  4. Measure the voltage according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    RR+ (E91-1) - GND (E90-7)
    R - BR
    Sounds signal (rear right)
    Audio system is operating
    Waveform synchronized with sound is output
    RL+ (E91-2) - GND (E90-7)
    B - BR
    Sounds signal (rear left)
    Audio system is operating
    Waveform synchronized with sound is output
    RR- (E91-3) - GND (E90-7)
    W - BR
    Sounds signal (rear right)
    Audio system is operating
    Waveform synchronized with sound is output
    RL- (E91-6) - GND (E90-7)
    Y - BR
    Sounds signal (rear left)
    Audio system is operating
    Waveform synchronized with sound is output
    FR+ (E90-1) - GND (E90-7)
    LG - BR
    Sounds signal (front right)
    Audio system is operating
    Waveform synchronized with sound is output
    FL+ (E90-2) - GND (E90-7)
    P - BR
    Sounds signal (front left)
    Audio system is operating
    Waveform synchronized with sound is output
    FR- (E90-5) - GND (E90-7)
    L - BR
    Sounds signal (front right)
    Audio system is operating
    Waveform synchronized with sound is output
    FL- (E90-6) - GND (E90-7)
    V - BR
    Sounds signal (front left)
    Audio system is operating
    Waveform synchronized with sound is output
    SW1 (E107-7) - SWG (E107-6)*1
    W - B
    Steering pad switch signal
    Steering pad switch not pushed
    2.97 to 3.56 V
    SW1 (E107-7) - SWG (E107-6)*1
    W - B
    Steering pad switch signal
    Steering pad switch
    SEEK+ switch pushed
    0.27 to 0.35 V
    SW1 (E107-7) - SWG (E107-6)*1
    W - B
    Steering pad switch signal
    Steering pad switch
    SEEK- switch pushed
    0.86 to 1.03 V
    SW1 (E107-7) - SWG (E107-6)*1
    W - B
    Steering pad switch signal
    Steering pad switch
    VOL+ switch pushed
    1.51 to 1.79 V
    SW1 (E107-7) - SWG (E107-6)*1
    W - B
    Steering pad switch signal
    Steering pad switch
    VOL- switch pushed
    2.22 to 2.66 V
    SW2 (E107-8) - SWG (E107-6)*1
    R - B
    Steering pad switch signal
    Steering pad switch
    not pushed
    2.97 to 3.56 V
    SW2 (E107-8) - SWG (E107-6)*1
    R - B
    Steering pad switch signal
    Steering pad switch
    MODE switch pushed
    0.27 to 0.35 V
    SW2 (E107-8) - SWG (E107-6)*1
    R - B
    Steering pad switch signal
    Steering pad switch
    ON HOOK switch pushed
    0.86 to 1.03 V
    SW2 (E107-8) - SWG (E107-6)*1
    R - B
    Steering pad switch signal
    Steering pad switch
    OFF HOOK switch pushed
    1.51 to 1.79 V
    SW2 (E107-8) - SWG (E107-6)*1
    R - B
    Steering pad switch signal
    Steering pad switch
    VOICE switch pushed
    2.22 to 2.66 V
    MIN+ (E102-2) - GND (E90-7)*1
    W - BR
    Microphone voice signal
    "Bluetooth" handsfree function is on
    Waveform synchronized with sound is output
    MIN- (E102-5) - GND (E90-7)*1
    R - BR
    Microphone voice signal
    "Bluetooth" handsfree function is on
    Waveform synchronized with sound is output
    MACC (E102-3) - GND (E90-7)*1
    B - BR
    Microphone AMP power supply
    Ignition switch off → on (IG)
    Below 1 V → 5 V
    SGND (E102-6) - Body ground*1
    Shielded - Body ground
    Shielded ground
    Always
    Below 1 V
    SPD (E107-3) - GND (E90-7)
    V - BR
    Speed signal
    Ignition switch on (IG)
    Drive wheels are turned slowly
    Pulse generation
    ALI (E107-17) - GND (E90-7)
    B - BR
    Sound signal (left)
    External device is playing (when stereo jack is used)
    Waveform synchronized with sound is input
    ARI (E107-15) - GND (E90-7)
    W - BR
    Sound signal (right)
    External device is playing (when stereo jack is used)
    Waveform synchronized with sound is input
    ASGN (E107-16) - Body ground
    R - Body ground
    Ground
    Always
    Below 1 V
    AGND (E107-18) - Body ground
    Shielded - Body ground
    Shielded ground
    Always
    Below 1 V
    AUXI (E107-19) - GND (E90-7)
    R - BR
    External input connection detection signal
    External device is connected
    Below 1 V
    LRHD (E107-20) - GND (E90-7)*2
    W-B - BR
    Ground
    Always
    Below 1 V
    *1: w/ "Bluetooth" Function
    *2: for RHD

    HINT:
    If the result is not as specified, the radio receiver may have a malfunction.