Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for DVD)

NAVIGATION SYSTEM (for DVD) > Noise Occurs

for Preparation Click here


INSPECTION PROCEDURE

1.NOISE CONDITION
  1. Check from which direction the noise comes.

    1. Front No. 1 speaker LH
    2. Front No. 1 speaker RH
    3. Rear No. 1 speaker LH
    4. Rear No. 1 speaker RH
    5. Front No. 2 speaker LH
    6. Front No. 2 speaker RH

    OK:
    The location of the noise source can be determined.



NG
Go to step 3
OK


2.CHECK SPEAKERS
  1. Check the installation conditions of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation or other malfunctions.

    Result 
    Result
    Proceed to
    A speaker is installed incorrectly
    A
    Foreign objects are in the speaker
    B
    A speaker cone is broken
    C
    No malfunction is found
    D



A
REINSTALL SPEAKER

B
REMOVE FOREIGN OBJECT

C
REPLACE SPEAKER
D


3.CHECK NOISE CONDITIONS
  1. Check the noise condition.

    HINT:
    The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.


    Condition Under Which Noise Occurs
    Noise Source
    Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped.
    Generator
    Noise occurs during A/C or heater operation.
    Blower motor
    Noise occurs when the horn switch is pressed and released or when pressed and held.
    Horn
    Noise occurs synchronously with the blink of the turn signal.
    Flasher
    Noise occurs during window washer operation.
    Washer
    Noise occurs during wiper operation.
    Wiper
    Noise occurs when the brake pedal is depressed.
    Stop light switch
    Others
    Static electricity

    HINT:
    1. In the left column of the chart, find the situation that matches the customer complaint. Then, in the right column, find the part that is causing the noise. Check the noise filter on or for the part.
    2. To save time and avoid a misdiagnosis, first make sure that the noise is not coming from outside the vehicle.
    3. Noise should be removed in descending order of loudness.
    4. Setting the radio to a frequency where no signal is received may make recognition of the noise problem easier.

    OK:
    The noise source cannot be determined.



NG
REPAIR OR REPLACE NOISE SOURCE
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)