Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

DTC    C1337/37    Different Diameter Tire Malfunction

for Preparation Click here


DESCRIPTION

The skid control ECU measures the speed of each wheel by receiving signals from the speed sensor. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must be equal.

DTC No.
DTC Detection Condition
Trouble Area
C1337/37
When vehicle speed is 20 km/h (12 mph), difference of 20% or more in average of front wheel speed and average of rear wheel speed continues for 20 seconds 3 times consecutively.
  1. Speed sensor circuit
  2. Tire size
  3. Brake actuator (skid control ECU)

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Check if the DTC(s) relating to the speed sensor circuit is output (Click here ).
    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2.CHECK TIRE SIZE
  1. Check tire size and condition of all 4 wheels.

    OK:
    All 4 wheels are the same size and in the same condition.



NG
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME IN SIZE
OK


3.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Drive the vehicle at more than 20 km/h (12 mph) for more than 60 seconds.

  1. Check if the same DTC(s) is output (Click here).
    Result 
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)