STEERING PAD (for Pin Type) > DISPOSAL |
| 1. DISPOSE OF STEERING PAD ASSEMBLY (WHEN INSTALLED IN VEHICLE) |
![]() |
Check if SST is functioning properly.
![]() |
Connect the SST's red clip to the positive (+) battery terminal and the black clip to the negative (-) battery terminal.
![]() |
Press the SST activation switch, and check that the LED of the SST activation switch illuminates.
Disconnect SST from the battery.
Follow the "Precaution" (Click here).
Disconnect the cable from the negative (-) battery terminal.
Remove the steering column cover lower .
![]() |
Install SST.
Disconnect the yellow airbag connector from the spiral cable.
Connect SST (A) to SST (B). Then connect SST (B)'s connector to the spiral cable.
![]() |
Move SST at least 10 m (33 ft.) away from the front side window.
Maintaining enough clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
Connect the SST's red clip to the positive (+) battery terminal and the black clip to the negative (-) battery terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
Press the SST activation switch and deploy the airbag.