Home › BRAKE › BRAKE › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT DISC BRAKE PAD
  1. Remove the 2 disc brake pads.



2. REMOVE ANTI-SQUEAL SHIM
  1. Remove the shims from each pad.



3. REMOVE NO. 1 PAD WEAR INDICATOR PLATE
  1. Remove the indicator plates from the pads.



4. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 4 plates from the brake cylinder mounting.



5. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH


    C127059
  1. Remove the 2 bolts and cylinder mounting.



6. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN


    C127070
  1. Remove the 2 pins (upper and lower) from the mounting.



7. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH


    C127071E01
  1. Using a screwdriver, remove the slide bush from the pin (lower).

    NOTICE:
    Be careful not to damage the pin.

    HINT:
    Tap the screwdriver tip before use.



8. REMOVE FRONT DISC BRAKE BUSH DUST BOOT


    C127072
  1. Remove the 2 boots from the mounting.



9. REMOVE CYLINDER BOOT


    C127060E01
  1. Using a screwdriver, pry out the set ring and boot.

    NOTICE:
    Be careful not to damage the brake piston and cylinder.

    HINT:
    Tap the screwdriver tip before use.



10. REMOVE FRONT DISC BRAKE PISTON


    G033449E02
  1. Place a piece of cloth between the piston and disc brake cylinder.

  1. Apply compressed air to remove the piston from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when applying compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.



11. REMOVE PISTON SEAL


    C127062E01
  1. Using a screwdriver, pry out the seal from the cylinder.

    NOTICE:
    Be careful not to damage the inner cylinder and piston seal groove.

    HINT:
    Tap the screwdriver tip before use.



12. REMOVE FRONT DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from the cylinder.



13. REMOVE FRONT DISC


    C127063E01
  1. Put matchmarks on the disc and axle hub.

  1. Remove the disc.