Home › BODY ELECTRICAL › LIGHTING › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH (for Fender Type)


B131442
  1. Detach the 2 claws and remove the light as shown in the illustration.

  1. Disconnect the connector and remove the side turn signal light.



2. REMOVE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH (for Mirror Type)


    E173275E01
  1. Using a moulding remover, detach the 4 claws and remove the mirror.

    HINT:
    Apply protective tape to the mirror body.



    E173276
  1. w/ Mirror Heater:

    1. Disconnect the 2 connectors.



3. REMOVE OUTER MIRROR COVER LH (for Mirror Type)


    E173278E01
  1. Using a screwdriver, detach the 8 claws and remove the mirror cover.

    HINT:
    1. Apply protective tape to the mirror body.
    2. Tape the screwdriver tip before use.



4. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH (for Mirror Type)


    E173279
  1. Remove the 2 screws and side turn signal light.

  1. Disconnect the connector.