Home › BODY ELECTRICAL › LIGHTING › HIGH MOUNTED STOP LIGHT ASSEMBLY

HIGH MOUNTED STOP LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE BACK DOOR CENTER GARNISH


    B129944
  1. Using a screwdriver, detach the 4 claws and 4 clips and remove the garnish.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR SPOILER


    B127943
  1. Remove the 3 bolts.



    B127944
  1. Remove the 3 clips and spoiler.

  1. Disconnect the center stop light connector and remove the rear spoiler.



4. REMOVE CENTER STOP LIGHT ASSEMBLY


B131434
  1. Disconnect the connector.

  1. Remove the 2 screws and center stop light.