Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER SWITCH

WIPER SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. w/ Navigation System (for HDD):
    After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE STEERING PAD ASSEMBLY


B130245E01
  1. Straighten the front wheels.

  1. Using a T30 "torx" driver, loosen the 2 screws until the groove along each screw circumference catches on the screw case.



    B127893E01
  1. Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver, disconnect the 2 airbag connectors.

    CAUTION:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Disconnect the horn connector and remove the steering pad.



4. REMOVE STEERING WHEEL ASSEMBLY


    C132123E01
  1. Remove the nut and place matchmarks on the steering wheel and steering column.



    C132124E02
  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (center bolt) before use.



5. REMOVE STEERING COLUMN COVER UPPER


    C128491
  1. Detatch the 4 claws, release the tilt lever and remove the lower steering column cover.



    C128492
  1. Detach the claw and remove the upper steering column cover.



6. REMOVE STEERING COLUMN COVER LOWER


    C128491
  1. Detatch the 4 claws, release the tilt lever and remove the lower steering column cover.



    C128492
  1. Detach the claw and remove the upper steering column cover.



7. REMOVE WIPER AND WASHER SWITCH ASSEMBLY


B133131
  1. Disconnect the connectors.

  1. Detach the claw and remove the wiper switch.

    NOTICE:
    Do not push the claw with excessive force as damage may occur.