Home › BODY ELECTRICAL › WIPER AND WASHER › WASHER MOTOR

WASHER MOTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. w/ Navigation System (for HDD):
    After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE RADIATOR SUPPORT OPENING COVER


B209240
  1. Remove the 9 clips and radiator support opening cover.



3. REMOVE CENTER HOOD CUSHION


    B209173
  1. Using a clip remover, remove the center hood cushion.



4. REMOVE RADIATOR GRILLE PROTECTOR


B209174
  1. Remove the 2 radiator grille protectors.



5. REMOVE FRONT FENDER FRONT SPLASH SHIELD LH


B208332
  1. Remove the screw, bolt, nut and splash shield.



6. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH

HINT:
Use the same procedure for the RH and LH sides.



7. REMOVE FRONT FENDER LINER LH


    B133187
  1. Using a screwdriver, remove the clip and fender liner retainer.

  1. Remove the screw, nut and bolt.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed later.



8. REMOVE FRONT FENDER LINER RH

HINT:
Use the same procedures described for the LH side.



9. REMOVE FRONT BUMPER COVER
  1. w/o Under Guard:
    Remove the front bumper cover .

  1. w/ Under Guard:
    Remove the front bumper cover .



10. REMOVE WASHER INLET SUB-ASSEMBLY


    B133130
  1. Remove the clip.



    B133122
  1. Pull the washer inlet of the washer jar upward to remove it from the windshield washer jar.



11. DRAIN WASHER FLUID
  1. Remove a washer hose from either of the washer motor and pumps, and drain the washer fluid.



12. REMOVE WINDSHIELD WASHER JAR ASSEMBLY (w/o Headlight Cleaner System)


    E200472E01
  1. for Large:
    Detach the 3 clamps.

  1. for Small:
    Detach the 2 clamps.



  1. Disconnect the 2 connectors.


    E200473E01

  1. Remove the 2 washer hoses from the washer motor and pumps.

  1. Remove the 3 screws. Then remove the washer jar.



13. REMOVE WINDSHIELD WASHER JAR ASSEMBLY (w/ Headlight Cleaner System)


    E200470
  1. Detach the 4 clamps.



    E200471
  1. Disconnect the 4 connectors.

  1. Remove the 3 washer hoses from the washer motor and pumps.

  1. Remove the 3 screws. Then remove the washer jar.



14. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY (w/ Headlight Cleaner System)


B133951
  1. Pull out the headlight cleaner motor and pump from the packing of the washer jar.



15. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


B133124E01
  1. Remove the washer motor and pump from the packing of the washer jar.



16. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY


B133125E01
  1. Remove the washer motor and pump from the packing of the washer jar.