Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM (w/o Entry and Start System)

KEY REMINDER WARNING SYSTEM (w/o Entry and Start System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the key reminder warning system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.
      Result: 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM
    A


    4.PROBLEM SYMPTOMS TABLE

      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here)

    2. Terminals of ECU (Click here)

    3. Data List / Active Test (Click here)


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END