Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


B131514
  1. Align the adjuster positioning hole with the claw, and install the adjuster with the 2 bolts as shown in the illustration.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



2. INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH


B131513
  1. Install the plate as shown in the illustration.

    HINT:
    Make sure the plate is firmly set into the garnish's claws.



3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH

NOTICE:
Do not disassemble the retractor.



    B131509E01
  1. Align the 2 claws with the seat belt positioning holes, and install the retractor of the outer belt with the bolt as shown in the illustration.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }



    B131508
  1. Connect the pretensioner connector as shown in the illustration.



    B122779
  1. Connect the outer belt with the shoulder anchor's bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



4. INSTALL CENTER PILLAR GARNISH LH


B129701
  1. Pass the outer belt anchor through the center pillar garnish.

  1. Attach the clip.

  1. Install the garnish with the 2 screws.



5. INSTALL CENTER PILLAR GARNISH LOWER LH


B131512
  1. Attach the 2 claws and 2 clips to install the garnish.

  1. Connect the floor anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Attach the lap belt outer anchor cover.



6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH


7. INSTALL REAR DOOR SCUFF PLATE LH (for Short Body)


    B129711
  1. Attach the 8 claws to install the scuff plate.



8. INSTALL REAR DOOR SCUFF PLATE LH (for Long Body)


    B129703
  1. Attach the 9 claws and 2 clips to install the scuff plate.



9. INSTALL FRONT DOOR SCUFF PLATE LH (for Short Body)


    B129699
  1. Attach the 10 claws to install the scuff plate.



10. INSTALL FRONT DOOR SCUFF PLATE LH (for Long Body)


    B129699
  1. Attach the 10 claws to install the scuff plate.



11. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH


12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL