Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT DOOR SCUFF PLATE LH (for Short Body)


    B129699
  1. Using a screwdriver, detach the 10 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE FRONT DOOR SCUFF PLATE LH (for Long Body)


    B129699
  1. Using a screwdriver, detach the 10 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
  1. Remove the front door opening trim weatherstrip.



5. REMOVE REAR DOOR SCUFF PLATE LH (for Short Body)


    B129711
  1. Using a screwdriver, detach the 8 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE REAR DOOR SCUFF PLATE LH (for Long Body)


B129703
  1. Using a screwdriver, detach the 9 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the garnish.



7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


8. REMOVE CENTER PILLAR GARNISH LOWER LH


    B131505E01
  1. Remove the lap belt outer anchor cover.

  1. Remove the anchor's built-in bolt from the pillar and disconnect the outer belt.



    B129700
  1. Using a screwdriver, detach the 2 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the garnish.



9. REMOVE CENTER PILLAR GARNISH LH


B129701
  1. Using a screwdriver, remove the 2 screws.

  1. Using a clip remover, detach the clip, then remove the garnish.

  1. Pull out the outer belt anchor from the center pillar garnish.



10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


B122779
  1. Remove the nut and disconnect the shoulder anchor.



    B131507
  1. Disconnect the pretensioner connector as shown in the illustration.



    B131509
  1. Remove the bolt and outer belt.



11. REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH


B131513
  1. Using a screwdriver, detach the 6 claws.

  1. Remove the anchor plate from the garnish.

    HINT:
    Tape the screwdriver tip before use.



12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


B131514
  1. Remove the 2 bolts and anchor.