FRONT SEAT INNER BELT ASSEMBLY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT SEAT TRACK BRACKET OUTER COVER LH |
Lift up the seat track adjusting handle and move the seat to the foremost position.
![]() |
Using a screwdriver, detach the 4 claws.
Remove the outer cover in the direction indicated by the arrow in the illustration.
| 3. REMOVE FRONT SEAT TRACK BRACKET INNER COVER LH |
![]() |
Using a screwdriver, detach the 2 claws.
Remove the inner cover in the direction indicated by the arrow in the illustration.
| 4. REMOVE FRONT SEAT TRACK BRACKET OUTER COVER RH |
Use the same procedures described for the LH side.
| 5. REMOVE FRONT SEAT TRACK BRACKET INNER COVER RH |
Use the same procedures described for the LH side.
| 6. REMOVE FRONT SEAT ASSEMBLY (for Power Seat) |
Operate the power seat switch knob and move the seat to the foremost position.
![]() |
Using a screwdriver, detach the 2 claws.
Remove the front seat track bracket outer cover in the direction indicated by the arrow in the illustration.
![]() |
Using a screwdriver, detach the 2 claws.
Remove the front seat track bracket inner cover in the direction indicated by the arrow in the illustration.
![]() |
Remove the 2 bolts on the rear side of the seat.
![]() |
Operate the power seat switch knob and move the seat to the rearmost position.
Remove the 2 bolts on the front side of the seat.
Operate the power seat switch knob and move the seat to the center position. Then, operate the power seat switch knob and move the seatback to the upright position.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the connectors under the seat.
Remove the seat.
| 7. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat) |
![]() |
Remove the 2 bolts on the rear side of the seat.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
![]() |
Remove the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.
Disconnect the connector under the seat.
Remove the seat.
| 8. REMOVE FRONT SEAT CUSHION INNER SHIELD LH (for Power Seat) |
![]() |
Remove the screw.
Using a screwdriver, detach the 3 claws.
Using a clip remover, detach the clip and remove the inner shield.
| 9. REMOVE FRONT SEAT CUSHION INNER SHIELD LH (for Manual Seat) |
![]() |
Remove the screw.
Using a screwdriver, detach the claw and clip. Then remove the inner shield.
| 10. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Power Seat) |
for Driver Seat:
Disconnect the 2 connectors and detach the 2 clamps.
for Passenger Seat:
Disconnect the connector and detach the 2 clamps.
![]() |
Remove the nut and seat belt.
| 11. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Manual Seat) |
for Driver Seat:
Disconnect the 2 connectors and detach the 3 clamps.
for Passenger Seat:
Disconnect the 2 connectors and detach the 3 clamps.
![]() |
Remove the nut and seat belt.