Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)


B118978E01
  1. Measure the resistance of the buckle switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened (Apply more than 29 N (3 kgf, 71 lbf) to occupant detection sensor)
    Below 100 Ω
    1 - 2
    Seat belt is fastened (Apply more than 29 N (3 kgf, 71 lbf) to occupant detection sensor)
    1 MΩ or higher

    If the result is not as specified, replace the inner belt assembly.



2. INSPECT OCCUPANT DETECTION SENSOR


B120567E01
  1. Measure the resistance of the sensor.

    Standard resistance:
    Condition
    Specified Condition
    Apply more than 29 N (3 kgf, 71 lbf) to occupant detection sensor
    Below 100 Ω
    Seat not occupied
    1 MΩ or higher

    If the result is not as specified, replace the front seat cushion pad.