Home › BODY › ENGINE HOOD / DOOR › HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD) > INSTALLATION

for Preparation Click here



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Install the cable to the clamps, wire harness protector and wire harness grommet as shown in the illustration.


    B127333E01



2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B127335E01
  1. Connect the cable to the lever.

  1. Attach the 3 claws to install the lever.



3. INSTALL HOOD LOCK ASSEMBLY


    B127328E01
  1. Connect the cable to the lock.

  1. Install the lock with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Adjust the lock.

  1. w/ Hood courtesy switch:
    Connect the connector.



4. INSTALL RADIATOR SUPPORT OPENING COVER


B209240
  1. Install the radiator support opening cover with the 9 clips.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL