Home › BODY › ENGINE HOOD / DOOR › FRONT DOOR

FRONT DOOR > ADJUSTMENT

for Preparation Click here


B057104E06

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
  4. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. w/ Navigation System (for HDD):
    After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. ADJUST FRONT DOOR PANEL SUB-ASSEMBLY LH


B129191
  1. Using SST, loosen the body's hinge bolts and adjust the door's position.

    SST
    09812-00010  

  1. Tighten the body's hinge bolts after the adjustment.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }



    B129189
  1. Loosen the door's hinge bolts and adjust the door's position.

  1. Tighten the door's hinge bolts after the adjustment.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }



    B129190
  1. Using a T40 "torx" socket, adjust the striker position by slightly loosening the striker mounting screws and then hitting the striker with a plastic-faced hammer.

  1. Using a T40 "torx" socket, tighten the striker mounting screws after the adjustment.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL