Home › BODY ELECTRICAL › HORN › INTEGRATION RELAY

INTEGRATION RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE ENGINE ROOM NO. 1 RELAY BLOCK COVER


2. INSPECT INTEGRATION NO.1 RELAY (UNIT A: HORN RELAY)


A124942
  1. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.



    B128358E02
  1. Measure the resistance of the integration relay.

    Standard voltage:
    Tester Connection
    Specified Condition
    1A-8 - 1C-1
    10 kΩ or higher
    1A-8 - 1A-5
    1A-8 - 1C-1
    Below 1 Ω (when battery voltage is applied to terminals 1A-7 and 1A-6)
    1A-8 - 1A-5

    If the result is not as specified, replace the integration relay.



3. INSTALL ENGINE ROOM NO. 1 RELAY BLOCK COVER