Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSPECTION

for Preparation Click here



1. INSPECT TRANSPONDER KEY AMPLIFIER


    E066577
  1. RHD and w/o Entry and start system, w/ Engine immobiliser system:

    1. Connect the battery's positive (+) lead to terminal 2 and the negative (-) lead to terminal 6, and then check that the light comes on.

      OK:
      LED illuminates.

      If the result is not as specified, replace the transponder key amplifier.



    I035769
  1. w/ Entry and start system and w/o Engine immobiliser system:

    1. Connect the battery's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1, and then check that the light comes on.

      OK:
      LED illuminates.

      If the result is not as specified, replace the transponder key amplifier.