Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


B209240
  1. Remove the 9 clips and radiator support opening cover.



2. REMOVE HOOD CENTER CUSHION


    B209173
  1. Using a clip remover, remove the center hood cushion.



3. REMOVE RADIATOR GRILLE PROTECTOR


B209174
  1. Remove the 2 radiator grille protectors.



4. REMOVE FRONT FENDER FRONT SPLASH SHIELD LH (w/ Diffuser)


B208332
  1. Remove the screw, bolt, nut and splash shield.



5. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH (w/ Diffuser)

HINT:
Use the same procedure for the RH and LH sides.



6. REMOVE FRONT BUMPER COVER


B208303
  1. Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the RH and LH sides.

  1. Remove the retainer.

    HINT:
    Use the same procedure for the RH and LH sides.



    B209203E01
  1. Put protective tape around the bumper cover.

  1. Using a clip remover, remove the 4 clips.

  1. Remove the 8 screws.



    B208307
  1. Detach the 4 claws and remove the bumper cover.

    HINT:
    The illustration only shows the LH side of the vehicle. The remaining claws are on the RH side.

  1. Disconnect the 2 fog light connectors.



7. REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY
  1. Disconnect the 2 horn connectors.

  1. Remove the 2 bolts and reinforcement.



8. REMOVE HEADLIGHT ASSEMBLY


E174641
  1. Remove the 3 screws and bolt.

  1. Disconnect the connectors and remove the headlight.