Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY


    B135621
  1. Attach the claw to install the headlight dimmer switch with the claw as shown in the illustration.



    B135620
  1. Install the headlight dimmer switch with the clamp.



    B088653
  1. Connect the connector.



2. INSTALL WIPER AND WASHER SWITCH ASSEMBLY


B133131
  1. Attach the claw to install the wiper switch.

  1. Connect the connectors.

    NOTICE:
    Do not push the claw with excessive force as damage may occur.



3. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Install the spiral cable onto the turn signal switch.



    C128493E03
  1. Connect all the connectors to the turn signal switch with spiral cable.



4. INSTALL STEERING COLUMN COVER


    C128492
  1. Attach the claw to install the upper steering column cover.



    C128491
  1. Attach the 4 claws to install the lower steering column cover.



5. INSTALL STEERING WHEEL ASSEMBLY


    C132123E02
  1. Align the matchmarks and install the steering wheel to the steering column.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect all the connectors to the spiral cable.



6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


7. INSPECT STEERING WHEEL CENTER POINT


8. INSTALL STEERING PAD ASSEMBLY


B127893E01
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.



    B130245E02
  1. Using a T30 "torx" driver, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. INSPECT STEERING PAD ASSEMBLY
  1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.

  1. Check that the horn sounds.



11. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).