HEADLIGHT DIMMER SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. REMOVE STEERING PAD ASSEMBLY |
![]() |
Straighten the front wheels.
Using a T30 "torx" driver, loosen the 2 screws until the groove along each screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.
Using a screwdriver, disconnect the 2 airbag connectors.
Disconnect the horn connector and remove the steering pad.
| 4. REMOVE STEERING WHEEL ASSEMBLY |
![]() |
Remove the nut and place matchmarks on the steering wheel and steering column.
![]() |
Using SST, remove the steering wheel.
| 5. REMOVE STEERING COLUMN COVER |
![]() |
Detatch the 4 claws, release the tilt lever and remove the lower steering column cover.
![]() |
Detach the claw and remove the upper steering column cover.
| 6. REMOVE SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Rise the steering column cover (upper).
![]() |
Detach the 4 clips and remove the column cover (upper).
![]() |
Detach the 3 claws and remove the spiral cable.
| 7. REMOVE WIPER AND WASHER SWITCH ASSEMBLY |
![]() |
Disconnect the connectors.
Detach the claw and remove the wiper switch.
| 8. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY |
![]() |
Disconnect the connector.
![]() |
Using needle-nose pliers, remove the band clamp as shown in the illustration.
![]() |
Using a screwdriver, detach the claws and remove the switch.