POWER WINDOW CONTROL SYSTEM > Key-off Operation Function Operates even if Operating Conditions are not Satisfied |

| 1.READ VALUE USING INTELLIGENT TESTER (LIN COMMUNICATION) |
Use the Data List to check the function of the power window regulator master switch.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Body ECU / Data List / Comm D-Door Mtr.
Read the indication displayed on the tester.
| Item | Measurement Item / Display (Range) | Status |
| Communication D-Door Motor | Connection status between power window regulator motor assembly (driver side) and main body ECU / OK or Stop | OK: Connection Stop: No connection |
|
| ||||
| OK | |
| 2.CHECK OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF |
Check the power window operation function after the ignition switch is turned off.
| Status | Proceed to |
| When power window can still be operated even after opening driver door or front passenger door within approximately 45 seconds of ignition switch being turned off | A |
| When power window can still be operated even after approximately 45 seconds have elapsed after ignition switch turned off | B |
|
| ||||
| A | |
| 3.READ VALUE USING INTELLIGENT TESTER (DOOR COURTESY LIGHT SWITCH) |
Use the Data List to check the driver side door courtesy switch signal.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Body ECU / Data List / D Dor Cty SW.
Read the indication displayed on the tester.
| Item | Measurement Item / Display (Range) | Status |
| D Door Courtesy Switch | Driver side door courtesy switch signal / ON or OFF | ON: Driver door open OFF: Driver door closed |
| P Door Courtesy Switch | Front passenger side door courtesy switch signal / ON or OFF | ON: Front passenger door open OFF: Front passenger door closed |
|
| ||||
| NG | |
| 4.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY |
![]() |
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Switch body | Pushed | 10 kΩ or higher |
| 1 - Switch body | Not pushed | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU) |
![]() |
Measure the voltage without removing the IA junction block connector.
| Tester Connection | Driver Door Condition | Specified Condition |
| IA-21 (DCTY) - Body ground | Fully closed | 10 to 14 V |
| IA-21 (DCTY) - Body ground | Open | Below 1 V |
| Tester Connection | Driver Door Condition | Specified Condition |
| IC-6 (DCTY) - Body ground | Fully closed | 10 to 14 V |
| IC-6 (DCTY) - Body ground | Open | Below 1 V |
| Tester Connection | Driver Door Condition | Specified Condition |
| IC-14 (PCTY) - Body ground | Fully closed | 10 to 14 V |
| IC-14 (PCTY) - Body ground | Open | Below 1 V |
| Tester Connection | Driver Door Condition | Specified Condition |
| IA-24 (PCTY) - Body ground | Fully closed | 10 to 14 V |
| IA-24 (PCTY) - Body ground | Open | Below 1 V |
|
| ||||
| OK | ||
| ||