FRONT DOOR SPEAKER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
![]() |
Using a screwdriver, detach the clip, 3 claws and remove the garnish.
| 3. REMOVE FRONT ARMREST BASE UPPER PANEL LH |
![]() |
Using a screwdriver, detach the clip, 5 claws, and remove the panel (with the switch).
Disconnect the switch connectors.
![]() |
for Driver Side:
Remove the 3 screws and power window regulator master switch from the panel.
![]() |
for Passenger Side:
Using a screwdriver, detach the 2 claws and remove the power window regulator switch from the panel.
| 4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
![]() |
![]() |
Remove the 3 screws.
Using a screwdriver, detach the 10 clips, 2 claws and remove the trim.
Using a screwdriver, detach the 7 claws and remove the weatherstrip inner.
Using a screwdriver, detach the 4 claws and remove the speaker door grille.
| 5. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY |
![]() |
Disconnect the connector.
Using a drill bit with a diameter of less than 4 mm (0.157 in.), drill out the 3 rivet heads and remove the speaker.
Continue drilling and push out the remaining rivet fragments.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.
| 6. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 2 screws and speaker.