Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR DOOR SPEAKER

REAR DOOR SPEAKER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH sides.
  2. The procedure listed below are for the LH side.



1. INSTALL REAR NO. 1 SPEAKER ASSEMBLY


    B131485
  1. Using an air riveter or hand riveter, install the speaker with 3 new rivets.

    NOTICE:

    1. B171664E02
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. B172390E12
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet to the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. B172391E02
      Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

  1. Connect the connector.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. Attach the 6 claws to install the weatherstrip inner.



    B133485
  1. Attach the 2 claws to install the inside handle.



    B137875E01
  1. for 8 Clip Type:
    Attach the 8 clips to install the trim board.

  1. for 7 Clip Type:
    Attach the 7 clips to install the trim board.

  1. Install the 3 screws.



    B129164
  1. Attach the 3 claws to install the door inside handle bezel plug.



    B130017
  1. Attach the 12 claws to install the door assist grip cover.



3. INSTALL REAR DOOR ARMREST BASE UPPER PANEL LH


    B133495
  1. Attach the 2 claws and install the power window regulator switch to the panel.

  1. Connect the switch connector.



    B133496
  1. Attach the clip and 5 claws to install the panel (with the switch).



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL