Home › BRAKE › BRAKE › VACUUM PUMP

VACUUM PUMP > ON-VEHICLE INSPECTION

for Preparation Click here



1. OPERATION CHECK
  1. Disconnect the vacuum hose from the vacuum pump.



    C128546E01
  1. Connect the hose of the vacuum gauge to the vacuum pump.

  1. Start the engine and warm it up for more than 2 minutes.

  1. With the engine idling, check the negative pressure of the vacuum pump.

    Standard pressure:
    More than 86.7 kPa (650 mmHg, 26 in.Hg)

    HINT:
    It is necessary to replace the vacuum pump every 200,000 km (124,000 miles).

  1. Remove the vacuum gauge from the vacuum pump.

  1. Connect the vacuum hose to the vacuum pump.