HEATER SWITCH > INSPECTION |
| 1. INSPECT HEATER SWITCH ASSEMBLY |
![]() |
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 (IN) - 4 (IG) | ON | Below 13.1 Ω |
| 1 (IN) - 4 (IG) | OFF | 10 kΩ or higher |
Apply battery voltage to the switch connector and check that the indicator light illuminates.
| Measurement Connection | Switch Condition | Specified Condition |
| Battery positive (+) → Terminal 4 (IG) Battery positive (+) → Terminal 5 (E) | ON | Indicator light Illuminates |
Apply battery voltage to the switch connector and check that the illumination light illuminates.
| Measurement Connection | Specified Condition |
| Battery positive (+) → Terminal 3 (ILL+) Battery positive (+) → Terminal 2 (ILL-) | Illumination light Illuminates |