Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for 2AD-FTV, 2AD-FHV)

CLUTCH UNIT (for 2AD-FTV, 2AD-FHV) > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH DISC ASSEMBLY


    C116574
  1. Using a vernier caliper, measure the rivet head depth.

    Maximum rivet depth:
    0.3 mm (0.012 in.)

    Replace the clutch disc assembly as necessary.

  1. Install the clutch disc to the transaxle.

    NOTICE:
    Take care not to insert the clutch disc in the wrong direction.



    C116729E01
  1. Using a dial indicator, measure the clutch disc assembly runout.

    Minimum runout:
    0.8 mm (0.032 in.)

    Replace the clutch disc assembly as necessary.



2. INSPECT CLUTCH COVER ASSEMBLY


    C116573E01
  1. Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

    Maximum:
    A (Depth):
    0.5 mm (0.020 in.)
    B (Width):
    6.0 mm (0.236 in.)

    Replace the clutch cover assembly as necessary.



3. INSPECT FLYWHEEL SUB-ASSEMBLY


    C116572
  1. Using a dial indicator, measure the flywheel runout.

    Maximum runout:
    0.1 mm (0.004 in.)

    Replace the flywheel sub-assembly as necessary.



4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY


    Q001060E01
  1. Turn the release bearing by hand while applying force in the axial direction.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.
    Replace the release bearing assembly as necessary.